ImageSnaped Event fired after acquisition timeout

Why is an ImageSnaped event fired after an acquisition timeout?

JAI A-Series Cameras Have a Different Pinout

Is there any difference in the pinout between the A-Series and the M-Series from JAI?

Using Several Grayscale Cameras on the PC-RGB

I have a PC-RGB and some grayscale cameras and I want to make use of the possibility to grab several grayscale cameras simultaneously by connecting them to the three colour channels of the PC-RGB. How do I do this?

FAQ: Camera Link

CamExpert problems saving write-protected config files

Why are changes in a camera config file sometimes not accepted when they are saved by the File->Save menu entry?

Changing Shutter Time of PULNIX TM1405GE Programmatically

I would like to programmatically change the shutter time of my PULNIX TM1405GE. What do I need to do?

Emulating a Standard COM Port on the PCCamLink Under IFC 5.2

How can I emulate a standard COM port on the PCCamLink under IFC 5.2 to use the Windows Hyper Terminal or other standard software with the built-in serial interface of the PCCamLink?

JAI CV-M4 CL Camera Link Standard Compatibility

The LEN and FEN signals of the JAI CV-M4 CL are active LOW. Is the camera not compatible to the Camera Link Standard which recommends a HIGH signal?

LinLog and External Exposure control

I use for my Photonfocus camera the PFRemote Control Tool . Why does LinLog not work when using a trigger mode with external Exposure control

Photonfocus MV-Dxxx and PFRemote

I want to configure a Photonfocus Camera from the MV-Dxxx series with PFRemote. When opening PFRemote I get the following Error message: Could not open Device Camwrapper: could not load DLL

When loading the Xcelera CVB Driver the debug window allways opens.

When loading the CVXceleraCLPX4.vin driver from any CVB application, the debug console windows allways opens and shows debug information. Even when the debug error log parameter in the .ini file is turned off. In addition the message: "INI-File not found -> Default values will be used." is shown in the error log.

Filtre